If you install new firmware on your Tecno Spark 10C KI5M, it can fix almost all software-related problems. It can help if your phone is slow, has errors, or is not working. You need some things before starting the flashing process. The correct firmware stock ROM for your Tecno Spark 10C phone, computer with a USB cable, SPD USB drivers, and SPD Flash Tool. You can easily download all the required files from this page. Follow the below steps carefully to flash your device.
Tecno Spark 10C KI5M Specification
The Tecno Spark 10C KI5M supports GSM, HSPA, and LTE networks and uses dual SIM cards. It has a 6.6-inch IPS LCD display with a 90Hz refresh rate. The KI5M runs on Android 12 with HIOS 8.6, powered by a Unisoc T606 chipset, and has an octa-core processor (2 Cortex-A75 and 6 Cortex-A55 cores). It has either 128GB of storage and 4GB of RAM, or 128GB of storage and 8GB of RAM. It has a 16 MP camera with an extra 0.08 MP lens, but the front one is 8 MP. Moreover, it supports Wi-Fi and Bluetooth connectivity and comes with a side-mounted fingerprint sensor. The phone has a 5000 mAh non-removable battery and supports 18W wired charging.
Pre-Requirements
Charge Your Battery: Ensure the KI5M has at least 50% charge before flashing.
Disable Sleeping Mode: Disable the computer from sleeping so that it would not sleep during this process.
Flash Tool Compatibility: Verify that the SPD flash tool is compatible with your operating system.
Disable Screen Lock: Before flashing your Tecno KI5M device, disable screen lock.
Save Accounts: Save all of your social media accounts before starting the process.
Backup Your Files: Flashing will delete all the data from your device, so back up all important files.
Confirm Firmware Version: Ensure that the firmware you have downloaded is the compatible version for your Tecno device.
Firmware Details
Brand: Tecno
Flash Tool: SPD Flash Tool
Drivers Supported: SPD USB Drivers
Firmware Type: Original Firmware
Firmware File Name: Tecno Spark 10C KI5M V133
Firmware File Size: 3.30 GB
How to Flash Tecno Spark 10C
- Download the Tecno Spark 10C KI5M Firmware and SPD Flash Tool on your computer.
- Extract the downloaded zip files with 7-zip on your computer.
- Download and install the SPD USB Drivers on your computer.
- Open the SPD Flash Tool folder and launch the SPD Flash Tool.
- Now, load the Firmware (Flash File) in the SPD Flash Tool.
- Power off your Tecno Spark 10C device completely.
- In Flash Tool, click “Start Downloading,” then connect your phone to the computer with a USB cable.
- After connecting your device to your computer, the flashing process will automatically start.
Advantages of Installing Firmware (Stock ROM)
- It removes harmful software or viruses that may be slowing down your Tecno KI5M.
- Flashing can restore your Tecno Spark 10C to its original state, but it will delete all files, so backup is needed first.
- Flashing can help the phone boot normally again if it has become stuck on the Tecno logo.
- It can reset or remove Factory Reset Protection (FRP) if you’re locked out after a reset.
- Flashing can remove apps that won’t uninstall.
- It can resolve issues related to music playback on your KI5M device.
- Flashing can be helpful when system updates are not installing properly.
Important Note: TecnoFirmware is not responsible for any damage that may happen to your Tecno Spark 10C device. Please proceed if you have sufficient knowledge about it.